Sterling Kitchen Utensil 1200 Manual De Usuario
BJ5-615
Chapter 6: Troubleshooting
54 of 85
Problem
Possible Cause
Possible Remedy
Too much feed material.
Reduce grinding material in-
feed.
feed.
Screen blocked.
Clean screen, check
condition, select larger
screen perforation if
necessary.
condition, select larger
screen perforation if
necessary.
V-belts slip.
Check V-belt tension and
condition. Re-tighten or
replace if necessary.
condition. Re-tighten or
replace if necessary.
Cutter condition.
Check cutters and re-
sharpen or replace if
necessary.
sharpen or replace if
necessary.
Cutting gap.
Check cutting gap and set
following the instructions in
this manual.
following the instructions in
this manual.
Discharge blocked.
Check if discharge conveyor
belt is running.
belt is running.
Current failure.
• Check limit switch for
defective contact.
• Check
electrical
connection.
• Tighten limit switch if
necessary.
Fuse too small.
Fit larger fuse only after
consulting the service
department.
consulting the service
department.
Rotational direction of rotor.
Check motor and reverse
polarity if necessary.
polarity if necessary.
Machine blocks or switches
itself off
itself off
Rotor speed.
Change rotor speed only
after consulting the
service department.
after consulting the
service department.
Cutter condition.
Check and sharpen if
needed following the
instructions provided in this
manual.
needed following the
instructions provided in this
manual.
Protruding bed cutter.
Consult the service
department.
department.
Rotor does not grip bulky
material.
material.
Cutters not aggressive
enough.
enough.
Fit underlay plates below
cutter holders.
cutter holders.