StarTech.com CONYX ECS0016 Manual De Usuario
Instruction Manual
91
Configuration)
Date and Time Configuration (Manually Change Clock Settings and
•
Network Time Protocol Time Zone)
Network Time Protocol Time Zone)
Network Configuration (Static and DHCP IP Configuration, Dial-in
•
Configuration and Services Configuration)
Configuration and Services Configuration)
Serial Port Configuration (Serial Port Settings, Supported Protocol
•
Configuration, Users and Trusted Networks)
Configuration, Users and Trusted Networks)
Event Logging Configuration (Remote Serial Port Log Storage and
•
Alert Configuration)
The ECS0016 runs a standard Linux kernel so it is also possible to con-
figure the gateway using other standard Linux and Busybox commands
and applications (ifconfig, gettyd, stty etc.) However doing this will not
guarantee these changes are permanent.
Please note: This chapter assumes you already have a certain level of
understanding before you execute Linux kernel level commands.
Alert Configuration)
The ECS0016 runs a standard Linux kernel so it is also possible to con-
figure the gateway using other standard Linux and Busybox commands
and applications (ifconfig, gettyd, stty etc.) However doing this will not
guarantee these changes are permanent.
Please note: This chapter assumes you already have a certain level of
understanding before you execute Linux kernel level commands.
The Linux Command line
Power up the ECS0016 and connect the “terminal” device:
1.
If you are connecting using the serial line, plug a serial cable
•
between the ECS0016 local DB9 port and terminal device. Configure
the serial connection of the “terminal” device/program you are using
to 115200bps, 8 data bits, no parity and one stop bit. If you are using
a program running on a Windows PC as the terminal device, then
the cable is made up from a Cat5 UTP (#440016) cable and two
DB9 to RJ45 adapters (#319000 and #319001)
the serial connection of the “terminal” device/program you are using
to 115200bps, 8 data bits, no parity and one stop bit. If you are using
a program running on a Windows PC as the terminal device, then
the cable is made up from a Cat5 UTP (#440016) cable and two
DB9 to RJ45 adapters (#319000 and #319001)
If you are connecting over the LAN then you will need to
•
interconnect the Ethernet ports and direct your terminal emulator
program to the IP address of the ECS0016 (192.168.0.1 by default)
program to the IP address of the ECS0016 (192.168.0.1 by default)
Log on to the ECS0016 by pressing ‘return’ a few times. The ECS0016
2.
will request a username and password. Enter the username root and
the password default. You should now see the command line prompt
which is a hash (#)
will request a username and password. Enter the username root and
the password default. You should now see the command line prompt
which is a hash (#)