Sonic Alert Telephone AMPLI600 Manual De Usuario

5

Wall mounting holes

screw

Slide the handset hanger bar out and rotate it 180 degrees. Slide it back 
into place.  The hook will now point up. This ensures the handset will not fall 
out of the cradle when it is mounted on the wall.

Plug the 8in short phone cord into the telephone jack on the AMPLI600, now 
run the phone cord under the wall plate adapter and through the opening.
Insert the Wall Plate adapter. Hold it so that the raised mounting pins line 
up with the phone’s keyholes on the AMPLI600. Once the holes are lined 
up, push the wall plate adapter in towards the AMPLI600 and then slide the 
plate upwards until it is securely placed on the phone.
Once the Wall Plate adapter is installed, plug the 8 inch short cord into the 
jack on the wall.
Holding the phone slightly above the mounting screws on the wall jack, 
push the phone against the mounting screws so they are hooked into upper 
and lower key-hole slots on the back of the phone. Slowly slide the phone 
down until it snaps into place.
Connect the handset curly cord to the handset and the other end to the 
telephone.
Lift the handset, if there is a dial tone, the telephone is ready for use.  If there 
is no dial tone, check that everything is plugged in as described above.