SonicWALL E6500 Manual De Usuario
Page 32
Configuring a State Sync Pair in NAT/Route Mode
Configuring a State Sync Pair in
NAT/Route Mode
NAT/Route Mode
This section provides instructions for configuring a pair of
SonicWALL NSA E6500 appliances for high availability (HA).
This section is relevant to administrators following deployment
scenario B.
SonicWALL NSA E6500 appliances for high availability (HA).
This section is relevant to administrators following deployment
scenario B.
This section contains the following subsections:
•
•
•
•
•
•
•
•
Initial High Availability Setup
Before you begin the configuration of HA on the Primary
SonicWALL security appliance, perform the following setup:
SonicWALL security appliance, perform the following setup:
•
On the bottom panel of the Backup SonicWALL security
appliance, locate the serial number and write the number
down. You need to enter this number in the High
Availability > Settings page.
appliance, locate the serial number and write the number
down. You need to enter this number in the High
Availability > Settings page.
•
Verify that the Primary SonicWALL and Backup
SonicWALL security appliances are registered, running the
same SonicOS Enhanced versions.
SonicWALL security appliances are registered, running the
same SonicOS Enhanced versions.
•
Make sure the Primary SonicWALL and Backup
SonicWALL security appliances’ LAN, WAN and other
interfaces are properly configured for failover.
SonicWALL security appliances’ LAN, WAN and other
interfaces are properly configured for failover.
SonicWALL NSA E-Class 2
Network Security Appliance
E6500
Local Network
SonicWALL
HA / Failover Pair
Internet
HA Link
NSA_E6500_GSG.book Page 32 Wednesday, June 17, 2009 7:16 PM