SMC Networks TIGERSWITCH SMC6752AL2 Manual De Usuario

2-5

The CLI program provides two different command levels — normal 
access level (Normal Exec) and privileged access level (Privileged Exec). 
The commands available at the Normal Exec level are a limited subset of 
those available at the Privileged Exec level and allow you to only display 
information and use basic utilities. To fully configure the switch 
parameters, you must access the CLI at the Privileged Exec level.

Access to both CLI levels are controlled by user names and passwords. 
The switch has a default user name and password for each level. To log 
into the CLI at the Privileged Exec level using the default user name and 
password, perform these steps:

1. To initiate your console connection, press <Enter>. The “User Access 

Verification” procedure starts.

2. At the Username prompt, enter “admin.”
3. At the Password prompt, also enter “admin.” (The password 

characters are not displayed on the console screen.)

4. The session is opened and the CLI displays the “Console#” prompt 

indicating you have access at the Privileged Exec level. 

Note: If this is your first time to log into the CLI program, you should 

define new passwords for both default user names using the 
“username” command, record them and put them in a safe place.

Passwords can consist of up to 8 alphanumeric characters and are case 
sensitive. To prevent unauthorized access to the switch, set the passwords 
as follows:

1. Open the console interface with the default user name and password 

“admin” to access the Privileged Exec level.