SMC Networks TIGERSWITCH SMC6752AL2 Manual De Usuario

IP I

NTERFACE

OMMANDS

4-249

IP Interface Commands

An IP addresses may be used for management access to the switch over
your network. The IP address for this switch is obtained via DHCP by
default. You can manually configure a specific IP address, or direct the
device to obtain an address from a BOOTP or DHCP server when it is
powered on. You may also need to a establish a default gateway between
this device and management stations or other devices that exist on another
network segment.

ip address

This command sets the IP address for the currently selected VLAN
interface. Use the no form to restore the default IP address.

Syntax

ip address {ip-address netmask | bootp | dhcp}
no ip address

• ip-address - IP address
• netmask - Network mask for the associated IP subnet. This mask

identifies the host address bits used for routing to specific subnets.

• bootp - Obtains IP address from BOOTP.
• dhcp - Obtains IP address from DHCP.

Table 4-67 IP Interface Commands

Command

Function

Mode Page

ip address