Siemens G85139 Manual De Usuario
English
2. INSTALLATION
G85139-H1750-U049-B
© Siemens plc 1997
26/09/97
4
2. INSTALLATION
2.1 Wiring Guidelines to Minimise the Effects of EMI
The inverters are designed to operate in an industrial environment where a high level of Electro-Magnetic
Interference (EMI) can be expected. Usually, good installation practices will ensure safe and trouble-free
operation. However, if problems are encountered, the following guidelines may prove useful. In particular,
grounding of the system 0V at the inverter, as described below, may prove effective. Figure 1 illustrates how
an RFI suppression filter should be installed.
Interference (EMI) can be expected. Usually, good installation practices will ensure safe and trouble-free
operation. However, if problems are encountered, the following guidelines may prove useful. In particular,
grounding of the system 0V at the inverter, as described below, may prove effective. Figure 1 illustrates how
an RFI suppression filter should be installed.
(1)
Ensure that all equipment in the cubicle is well earthed using short, thick earthing cable connected to
a common star point or busbar. It is particularly important that any control equipment that is
connected to the inverter (such as a PLC) is connected to the same earth or star point as the inverter
via a short, thick link. Flat conductors (e.g. braids or metal brackets) are preferred as they have lower
impedance at high frequencies.
a common star point or busbar. It is particularly important that any control equipment that is
connected to the inverter (such as a PLC) is connected to the same earth or star point as the inverter
via a short, thick link. Flat conductors (e.g. braids or metal brackets) are preferred as they have lower
impedance at high frequencies.
The return earth from motors controlled by the inverters should be connected directly to the earth
connection (PE) on the associated inverter.
connection (PE) on the associated inverter.
(2)
Wherever possible, use screened leads for connections to the control circuitry. Terminate the ends of
the cable neatly, ensuring that unscreened wires are as short as possible. Use cable glands
whenever possible.
the cable neatly, ensuring that unscreened wires are as short as possible. Use cable glands
whenever possible.
(3)
Separate the control cables from the power connections as much as possible, using separate
trunking, etc. If control and power cables cross, arrange the cables so that they cross at 90° if
possible.
trunking, etc. If control and power cables cross, arrange the cables so that they cross at 90° if
possible.
(4)
Ensure that contactors in the cubicle are suppressed, either with R-C suppressors for AC contactors
or ‘flywheel’ diodes for DC contactors, fitted to the coils. Varistor suppressors are also effective.
This is particularly important if the contactors are controlled from the relay on the inverter.
or ‘flywheel’ diodes for DC contactors, fitted to the coils. Varistor suppressors are also effective.
This is particularly important if the contactors are controlled from the relay on the inverter.
(5)
Use screened or armoured cables for the motor connections and ground the screen at both ends via
the cable glands.
the cable glands.
(6)
If the drive is to be operated in an Electro-magnetic noise-sensitive environment, the RFI footprint
filter kit should be used to reduce the conducted and radiated interference from the inverter. For
optimum performance, there should be a good conductive bond between filter and metal mounting
plate.
filter kit should be used to reduce the conducted and radiated interference from the inverter. For
optimum performance, there should be a good conductive bond between filter and metal mounting
plate.
On no account must safety regulations be compromised when installing inverters!