Siemens TRAFFIC CONTROLS TC12 Manual De Usuario

 

TC12 Installation, Commissioning & Maintenance Handbook 

ut bit select: 0-7} = {group select: 0-7,255} 

Comment: 

Used to select the DFM time limits set up by GMA and GMI for the 

or all inputs is 255, which 

indicates that no DFM is required on those inputs. To start the 

 any value above 7 disables monitoring, it is 

suggested that only 255 is used. 

Comment: 

Setting this value to a valid input number (i.e. 0 to 31) provides a 

y (for use with a green wave box). If the allocated 

i.e. "1") then all the OTU output relays are 

 
Notes.  
The 32 inputs are numbered 1 to 32 in se tion 3.2.3.5, corresponding to the 
associated pin on the 40 way input c

umbers the inputs from 

T
 

efer to the following section (3.3.3.27) for more details of Fault Flags and their 

GMG {input byte select: 0-11} {inp

input specified. The default value f

monitoring of an input, use this command to allocate an input to a 
DFM group. Although

 

GLT={Digital input no.: 0 to 31} (255) 

lamp test facilit
input is active (
energised. The default value is 255 - lamp test facility disabled. 

c

onnector, however the handset command 

0 to 31, for the 32 inputs. 

n
 

his facility is included in PB391 issue 2 firmware (and above). 

 

GFS (Fault Flag number : 0-31)  

Comment: 

Displays Fault Flags and data as text. (This is available on PB392 

issue 6 or later) 

 

R
explanations. 
 

666/HE/43100/000  

Page 96 

Issue 9