Siemens TRAFFIC CONTROLS TC12 Manual De Usuario

 

TC12 Installation, Commissioning & Maintenance Handbook 

For sensors monitoring a phase or wait indicator, the value entered defines the 

, 2=phase C etc. 

se together, the value 

e A 

 

a
 
0  = pha

ry signs the value = 255. 

 assumes that the controller will perform 

 

 

KDL = (0 to 25

Comment:   Maximum number of dim/bright changes in a 24 hour period that 

are allowed before a dim change fault is indicated. 

ring. 

KFD (0 - 1) = ( - 255

Comment: 

ome 

ntrollers have a long term flashing mode that 

nnot

red by the LMU. During the flashing period the 

LMU can be disabled by allocating an input to inform the LMU that 
the signals are flashing. There are two possible input types that can 
be used:  

 

 

 

KFD 0 = (input number: 0 - 31) (255 to disable).  

This allocates a suitably configured controller output to the OTU 
input that goes active when the signals enter flashing mode. 

phase identity, i.e. 0=phase A, 1=phase B
 
For sensors monitoring a vehicle and a pedestrian pha
entered defines the vehicle phase identity and the pedestrian phase is by default 
allocated the next phase identity, e.g. a value of 0 allocates the vehicle to phas
and by default the pedestrian is allocated phase B. 
 
For sensors monitoring switched signs, the value entered defines the drive phase

nd colour: 

se A, red drive 

1  = phase B, red drive 
etc 
 
16 = phase A, amber drive 
17 = phase B, amber drive 
etc 
 
32 = phase A, green drive 
33 = phase B, green drive 
etc. 
For sensors which are unused or monitoring regulato
 

KDP = { 0 or 1 } (1) 

Comment:   The default configuration

dim/bright changeovers. If there is no change in a 24 hour period a
dim change fault is indicated. For controllers with no dimming 
facility set KDP = 0 to disable this monitoring function. 

5) (63) 

Note:  Setting KDP = 0 does not affect this monito

 

0 

) 

S

export co

ca

 be monito

666/HE/43100/000  

Page 104 

Issue 9