Siemens TRAFFIC CONTROLS TC12 Manual De Usuario

 

TC12 Installation, Commissioning & Maintenance Handbook 

The power supply for the modem PCB and Instation Test Set Logic PCB is the 
same type as used on the Instation PSU PCB. Refer to section 2.2.4.1 for a 
description of how to set the voltage range of this power supply. 
 

Note.  The voltage range of the PC used in the Instation Test Set should be 

checked in the manufacturer's literature and note should be taken of any 
links/switches that need setting for different voltage ranges. 

 

The Instation Test Set software is installed by Engineering at Poole before the 
Test Set is shipped.  
 
The software set up on the Instation Test Set PC should not be changed. If there 
are operational reasons for changing the software set up, the UTC Software 
Support Desk (01202 782440 or 

utcsupport@poole.siemens.co.uk

) should be 

consulted before making any changes. 
 

During start up the test set software checks that it can access all the items that it 
needs. If any errors occur a message will be displayed which indicates the cause 
of the error. 
 
If the test set cannot access either of the two necessary serial ports, an error 
message will be displayed in which the status number has the following 
significance: 
 

-2 

Invalid Port    

 

 

 

Contact engineering at Poole 

-4 

Invalid Buffer Size   

 

 

Contact engineering at Poole 

-5 No 

Memory 

    Contact 

engineering 

at 

Poole 

-6 

Port Not Set Up Correctly   

 

Contact engineering at Poole 

 
-3 

Port Is Already In Use 

 

 

Re-boot PC 

 
-14 

Port Required Could Not Be Found 

Ensure machine is configured for 

 

       two 

serial 

ports; 

COM1 

and 

COM2 

 

If the software fails to complete start up with the PC with error message "Internal 
Stack Overflow". This can indicate that the hardware connected to the parallel port 
is not powered correctly, i.e. the test set logic PCB. 
 

666/HE/43100/000  

Page 137 

Issue 9