Manualsbrain.com
  1. Manuales
  2. Marcas
  3. Siemens
  4. TRAFFIC CONTROLS TC12
  5. Manual De Usuario

Siemens TRAFFIC CONTROLS TC12 Manual De Usuario

Descargar
Página de 201
 
TC12 Installation, Commissioning & Maintenance Handbook 
(10) If the indications for the DIGI I/O and IMD cards are as expected, move 
across to the
nd hit return. The TC12 
Software wil
e PC. Should the DIGI 
I/O cards and/or IMD cards not be shown as expected then choose the 
‘Quit’ option and correct the problem. 
(11)  Exit the Installation software. Eject the TC12 Software disk and keep this as 
2 cabinet. 
2.2.
ed 
correctly in PC slot, check switch settings of Port address 
Digi I/O cards (see section 
heck Ram address switches set up 
e section 2.2.2.8). 
 
Switches set correctly - change to next available address 
). 
2.2.2
he PC is accessible from the back of the Instation. It is placed on the PC 
ounting chassis (6
 of the Instation. 
ication 
he 
Master switch Panel assemb
e the possibility of the cables chafing against the 
 m
D card in the PC, care should be taken to 
IMD cables chafing on the solder side of 
jacent PC
 possible the IMD PCBs should be located 
en the IMD cables and adjacent PCBs. 
 
 'Install' menu, select the 'Yes' option a
l now be installed on the Hard disk of th
a backup. 
(12)  Disconnect the PC from the mains and disconnect the monitor. The PC can 
now be installed in the TC1
 
2.11.1  Error Messages during TC12 Instation PC Software Installation 
Messages and Errors that may be displayed on the 'Digital I/O boards' and 'IMD 
boards' status menus during the software installation and suggested corrective 
actions are shown below: 
 
Displayed Message 
Action to be taken 
OK 
None - Card installed OK 
Not Installed 
None unless card should be present; check card is insert
for IMD cards or address for 
2.2.2.7 or 2.2.2.8).  
Ram Error 
IMD cards only - c
correctly on card (se
 
Switches set incorrectly - correct and restart installation. 
Faulty Replace 
card. 
Int. Failed 
Check Interrupts set up correctly on the card (see2.2.2.8
 
.12  PC Mounting Chassis 
T
m
67/2/22621/000), which is a shelf at the top
The PC is not visible from the front of the Instation as the System Fault Ind
Panel is fitted across the fron
ocket on t
t. The PC mains lead plugs into a s
ly at the back of the Instation.  
 
Note:  Lengths of 'U' channel (e.g. 915/4/03641/000) should be cut and placed 
along the edges of the cut-outs in the back of the PC through which cables 
pass, in order to eliminat
edges.  
    
there is
If 
ore than one IM
avoid the possibility of the 
is
ad
Bs. As far as 
such that a spare slot exists betwe
666/HE/43100/000  
Page 21 
Issue 9