Siemens HICOM 300 Manual De Usuario
18
Installing the Gigaset USB Adapter 300
Gigaset USB Adapter 300 / multilanguage / A31008-M1066-R101-2x-7619 / installation.fm / 14.11.2008
Sc
hablone 200
4_12
_27
If no connection is currently active, a red cross appears above the icon and Discon-
nected appears in the QuickInfo.
nected appears in the QuickInfo.
Reading the connection quality on the icon
The icon changes gradually depending on the current connection quality. The better the
connection quality, the higher the transmission speed.
connection quality, the higher the transmission speed.
With reasonable to poor connection:
ì
If possible, move your PC closer to the connection partner for greater field strength.
Status indicators
The Gigaset USB Adapter 300 has two status indicators (LEDs). They are used to indicate
the
u Operating status (Power), green
u Transmission status (Link/Act), green
the
u Operating status (Power), green
u Transmission status (Link/Act), green
No WLAN available (red cross over bar)
There is no LAN available to which you could establish a connection within
the reach of your Gigaset USB Adapter 300.
There is no LAN available to which you could establish a connection within
the reach of your Gigaset USB Adapter 300.
ì
Check the configuration of the access point and adjust the settings for
the Gigaset USB Adapter 300 accordingly.
the Gigaset USB Adapter 300 accordingly.
OR
ì
Change your location to reduce the distance to a connection partner.
LED
State
Meaning
Power
On
The Gigaset USB Adapter 300 was installed successfully
on your PC and is ready for operation.
on your PC and is ready for operation.
Off
The device is not ready.
WLAN
On
There is no connection to the wireless network.
Blinking
Data is being transmitted.
Off
There is currently no data traffic.