Sapphire Audio DV425TR Manual De Usuario

02/01                                                                                     Page 16                                                                               250-5533

KIT CONTENTS: Blower motor; snapdisc bracket with wire 

harness; rheostat, rheostat nut; knob;  screws; 1 zip-tie.  

TOOLS REQUIRED:  #2 Phillips head bit; hand drill; 11/16's 

wrench.
1.  Mount blower to rear of unit using two screws.  See Fig. 1

2.  Beneath the stove from its front side, ensure that all wiring 

is moved behind the blower mounting bracket, and complete 

blower mounting by inserting two screws.  See Fig. 2 

3.  Make the wire harness connection. Fig. 2

4.  Use 2 screws to connect the snapdisc bracket to blower 

mounting bracket. Fig. 3

5.  Route wires from snapdisc to the right, upper edge of blower. 

Fig. 3

6.  Insert rheostat control into it's opening from beneath the 

control panel.  Fit the rheostat nut on top and tighten the nut 

using an 11/16" wrench.  Attach black knob. Fig. 4

7.  Gather any excess in the wiring and zip-tie to the switch 

wires and piezo wire at rear of stove.

Note:  This blower utilizes a snapdisc to control ON and OFF 

operation.  When the correct temperature is reached, the 

blower will automatically turn ON.  Use the rheostat knob to 

adjust the fan to High or Low to suit your preferences.

Refer to page 56, Parts & Accessories for specific color part 

numbers.

Hearth legs will allow three additional inches of clearance.  Be 

sure to calculate this distance correctly if necessary to cut wall 

hole to install horizontally.  Refer to Dimensions on page 7.

To change legs, use a 1/2" wrench to remove and replace one 

leg at a time while the unit is in an upright position.