Saleen REAR WING KIT S281SC Manual De Usuario

Descargar
Página de 12
 
12
 
 
Figure 24 
   Figure 23 
Tighten 
nut in 
here 
26. Place one washer (00-9004-
C11804*) and one hex nut (00-
9003-C11803*; use red Loctite) 
over each (2 total) of the furthest 
inboard studs (those that are not 
easily visible) and tighten with an 
angled ratcheting 7/16” wrench 
(Figure 23 is a close-up of Figure 
22; Figure 24 is a view of the inside 
of the deck lid, and shows the nut 
on the studs). Torque the nuts to 5 
lb-ft.
 
27. Remove the rope from the deck lid. 
28. Using the oval rubber plug (00-
9009-C11813*) cover each of the 
two holes drilled out with the 
electric dremel in step 12. (Figures 
11,12) 
29. Check to make sure you have 
placed a nut on every stud on the 
wing – four per side, or eight total 
(four regular hex nuts and four 
acorn hex nuts). Make sure all nuts 
have been tightened securely and 
torqued. 
Figure 22