Ridgid RD80763 Manuales De Servicio

14

You may use this tool for the purposes listed below:
 Removing dirt and mold from decks, cement patios, and 

house siding

 Cleaning cars, boats, motorcycles, outdoor furniture, and 

grills

Do not run the pump without the water supply con-
nected  and  turned  on.  This  will  damage  the  high 
pressure seals and decrease pump life.

Before starting the engine, connect all hoses and check all 
fluids (oil and gas). Turn the garden hose on then squeeze 
the trigger. This relieves air pressure caused by turning on the 
water. Hold the trigger until a steady stream of water appears.
To start an engine that is cold or has run dry:
  Close the fuel valve.
  Fill the fuel tank (if necessary).
  Connect the garden hose to the pump and turn on the 

water supply.

  Open the fuel valve.
  Place the engine switch in the 

ON ( l ) position.

  Push the choke lever to position 

A (CLOSED) position.

 

NOTE: If the engine is cold, close the choke fully. If the 
engine is warm, open the choke lever half-way or keep it 
opened fully.

 Give  the  recoil  starter  short,  brisk  pulls  to  start  the  

engine.

 If  the  engine  fires,  or  begins  to  sputter  and/or  cough 

without catching, move the choke lever to the half-way 
position.

 

NOTE: Never pull the recoil starter more than four or five 
times with the choke closed as this causes flooding.

 With the choke in the half-way position, pull the recoil 

starter again. The engine should now start.

 

NOTE:  If the choke remains in the closed position, the 
engine will continue to sputter and/or cough but will not 
start.

 Return the recoil starter gently to the engine housing. Do 

not allow the rope to snap back.

 As the engine warms up, move the choke lever slowly to 

position 

B (OPENED).

 Let the engine warm up a few minutes before using.
To stop the engine using the engine switch:
  Turn the engine switch to 

OFF ( O ) position.

  Close the fuel valve.

Fig. 15

Fig. 14

Fig. 16