Proxim AP-4000 Manual De Usuario

Parameter Tables

–

 - Monitor link status

•

 - Configure Wireless and Ethernet settings

–

—

 - View and configure blacklisted channels

—

 - Configure the WDS partnerships

–

 - Configure the SSIDs, VLANs, and security modes for each 

interface. Up to 16 SSIDs per wireless interface are supported;  different security settings can be applied to each 
SSID, and a unique VLAN can be configured per SSID.

–

 - Set the speed and duplex of the Ethernet port.

–

 - Configure the Mesh network.

•

 - Control access to the AP’s management interfaces

–

 - Set read and read/write passwords

–

 - Set up the graphical web browser interface. If required, enable SSL and configure the SSL 

certificate passphrase.

–

 - Telnet Port setup

–

 - Serial Port setup

–

 - Configure RADIUS Based Management Access for HTTP and 

Telnet access.

–

 - Enable SSH and configure the host key.

–

 - Set up for file transfers; specify IP Address, file name, and file type

–

 - Configure range of IP addresses that can access the AP

–

 - Configure the Auto Configuration feature which allows an AP to be automatically 

configured by downloading a configuration file from a TFTP server during boot up.

•

–

 - Control network traffic based on protocol type

–

 - Enable and disable specific addresses

–

 - Enable or disable proxy ARP for wireless clients

–

 - Control which ARP messages are sent to wireless clients based on IP settings

–

 - Control the type of broadcast packets forwarded to the wireless network

–

 - Filter IP packets based on TCP/UDP port

•

–

 - Enter the list of IP addresses that will receive alarms from the AP 

–

 - Configure the AP to send Syslog information to network servers

•

–

 - Used to help prevent network loops

–

 - Set threshold for number of broadcast packets

–

 - Enable or disable peer to peer traffic on the same AP

–

 - Redirect traffic from wireless clients to a specified MAC address

•

–

 - Configure RADIUS Servers and assign them to VLANs.

•

 - Access Point security settings

–

 - Control wireless access based on MAC address

–

 - Enable and configure Rogue Scan to detect Rogue APs and clients.

–

 - Configure 802.1X Supplicant Timeout parameter