Petsafe Beverage Dispenser 400-1255-19 Manual De Usuario

Once the stator is removed, you 

can also remove the impeller (3 

white-bladed propeller) which 

is held in place magnetically. 

To remove the impeller, use a 

fingernail to get under a blade 

and lift out. (Fig. 4e) 

5)

Once the motor is disassembled you can clean the parts 

with warm soapy water. Use a cotton bud or the Drinkwell

®

 

Cleaning Kit “Motor Brush” to get into the motor cavity and 

remove any build-up. For added disinfecting and hard water 

removal, clean the motor with white vinegar.

Once the parts are clean you can reassemble the motor for 

use. 

a) Replace the impeller

b) Replace the stator

c) Replace the intake plate with the flow control knob

    attached to it. 

Fig. 4e

6)

7)

If you live in a humid environment and have problems with mold 

or algae, soak all of the parts in a diluted bleach solution for about 

10  minutes  after  regular  cleaning.  Use  a  10%  bleach  and  90% 

water solution. Pour some of the bleach solution down into the 

motor cavity too. This is an excellent way to disinfect the fountain. 

However, you must be sure to rinse all the parts thoroughly in only 

water to remove all the chlorine. 

If  you  have  “hard  water”  you  may  start  to  see  white  mineral 

deposits on or down inside the pump. This may eventually prevent 

the impeller from turning properly. To avoid having to replace the 

pump, please take the following steps:

1.  Clean the pump more frequently than you have in the past; or

2.  Clean the pump with a vinegar solution (20% White Vinegar and 

80% Water) and let the solution soak for several minutes down 

inside the motor cavity; or

3.  Use bottled water instead of faucet water.