Tyco Electronics M/A-COM MM23016 Manual De Usuario

74 

Pressing and holding the CLEAR (Scan Model) or CLR (System Model) button for 2.5 seconds toggles 
the user into and out of the dynamic regroup group set. A double beep will sound for entry or exit. The 
display will indicate REGR_0x where "x" is a digit of 1 to 8 indicating the group when dynamic regroup 
has been enabled by the user. If the radio is in dynamic regroup and the user selects a group that has not 
been regrouped, the display will show NO ENTRY. The radio will be prevented from transmitting and 
receiving calls in this condition except for scanned groups. 

If the pre-programmed group set on the currently selected system contains an EMER/HOME group and 
the radio is in dynamic regroup, the radio will exit dynamic regroup and declare the emergency on the 
HOME group. If no EMER/HOME group is present, the radio will declare the emergency on the currently 
selected dynamic regroup group. 

 

Page sends a PING message to a radio and functions similar to Individual Call.  

The following procedures describe how to initiate and complete a Page. 

1.  To select a previously stored individual, select the Page mode from the menu followed by the 

 

ramp control to scroll through the list of stored individuals. The selection mode rules apply. While in 
the individual call list, the menu key toggles the display between the call name and the unit ID 
number. On System model radios, the individual’s unit ID can also be entered directly from the 
keypad. 

2.  Press the PTT button; the radio performs the necessary signaling on the control channel. On the 

calling radio, line 1 shows the called individual's name if found in the list of stored individuals or ID 
followed by the logical ID number of the unit being called. If the receiving radio receives the Page 
and responds, both radios will emit three high-pitched tones. The receiving radio will also display 
PAGE and the ID of the calling radio.