Triton Tools Sander TCROS 4.5 Amps Random Orbital Sander Manual De Usuario

GB

GB

Waste electrical products should not 

be disposed of with household waste. 

Please recycle where facilities exist. Check 

with your local authority or retailer for 

recycling advice.

Always wear ear, eye and  

respiratory protection.

 

Double insulated.

Instruction warning.

Instruction note. 

•  When connected 

to mains power the 

sander is switched 

“on” and “off” via the 

power switch (3) at 

the front of  

the sander.

•  Push the “I” side of the switch firmly inward 

until it clicks to the on position. To switch 

off press in the “O” side of the switch.

•  Hold the tool securely and make sure that 

you have full control at all times.

•  Remove the sander from the workpiece 

before switching off.

The speed can be adjusted to suit the material 

being sanded. “1” being the lowest speed and 

“6” being the highest. Higher speeds tend to 

cut faster and produce a smoother finish.
•  To adjust the  

speed, move the 

variable speed dial

(4) until the desired 

sanding results  

are achieved. 

•  For optimum dust extraction, remove  

the dust bag (7) when it is no more than 

half full and shake the contents into a bin 

or container.

•  Do not use the dust bag when sanding 

metal. The hot metal particles could cause 

residual wood dust or the internal bag 

itself to catch fire.

•  Periodically remove 

the bag from the 

adaptor for washing 

in warm soapy water.  

Make sure the bag is 

completely dry before 

replacing it.

1. Push the dust bag (7) fully into the large 

opening of the dust bag adaptor (6).

2. Push the dust bag adaptor onto the dust 

extraction port (5) of the sander.

 

The dust bag  

         can be rotated 

to allow best access 

for the sander when 

sanding difficult 

workpieces.
3. The dust extraction port can be connected 

directly to a household vacuum cleaner 

or workshop dust extraction system if 

preferred over the dust bag.

Before fitting sandpaper, remove any dust or 

debris from the hooks and loops of the base.
1. Match the holes in the sanding disc (8)

with the holes in the sanding base (2)  

and press it evenly into position.

2. To remove the sheet, peel it away from  

the base.

 Use only 5" diameter sanding  

discs with 13/32" ventilation holes  

and hook & loop backing.

 Take care to regularly clean out  

the build up of dust on the base. 

 

•  Replace damaged cords immediately.  

Use of damaged cords can shock, burn  

or electrocute.

•  If an extension cord is necessary, a cord 

with adequate size conductors should be 

used to prevent excessive voltage drop, 

loss of power or overheating. The table 

shows the correct size to use, depending 

on cord length and nameplate amperage 

rating of tool. If in doubt, use the next 

heavier gauge. Always use U.L. and CSA 

listed extension cords.

 

 

 

 

 

25ft 

50ft 

100ft 

150ft

3–6 

120V~ 

18 

16 

16 

14

6–8 

120V~ 

18 

16 

14 

12

8–10 

120V~ 

18 

16 

14 

12

10–12 

120V~ 

16 

16 

14 

12

12–16 

120V~ 

14 

12 

- 

-

6

Symbols

7

Functions