Paxton Automotive Musical Table 4PFX020-020 Manual De Usuario

Disconnect the fuel lines from the fuel
pump.

Remove the fuel pump.

Install the supplied fuel pump and gasket
using the stock hardware.

Attach the supplied vacuum hose to the barb
fitting on the fuel pump. The other end of
this hose will be connected to the carburetor
enclosure in a later step.

Install the 1/4" NPT to 3/8" barb 90º in the
fuel pump outlet.

Install the 1/4" NPT to 5/16" barb straight in
the fuel inlet. (See Fig. 4-f.)

Section 4

FUEL PUMP REPLACEMENT

Re-attach the fuel supply line using the fac-
tory hose clamp.

Attach the supplied 3/8" fuel line from the
fuel pump outlet to the supplied fuel filter.
Attach a piece of 3/8" fuel line to the filter-
out and then route up to where the carbure-
tor enclosure will be installed. Install and
tighten the supplied hose clamps on all con-
nections.

Install the supplied –6 90º hose end into the
open end of the 3/8" hose where it will con-
nect to the bulkhead fitting on the carburetor
enclosure.