Polaris TBM 200 LH Manual De Usuario

 

 
 
 
 
INSTALLATION, OPERATION AND MAINTENANCE MANUAL 
POLARIS - SERIES TBM 200 LH ( 8” ) - TYPE PHO / PBO / PVO 

5of 29 

DOCUMENT NBR. : 

REVISION:  

EFFECTIVE 
DATE: 

 

 

 
Seller warrants that the products covered by this contract conform to applicable drawings and 
specifications accepted in writing by Seller, will be free from defects in material and workmanship, 
will be merchantable and will perform in accordance with the detailed specifications accepted in 
writing by Seller. 
These warranties extend for a period of twelve (12) months from the date of purchase by Buyer. 
Buyer’s exclusive remedy and Seller’s sole duty under these warranties is to repair or replace the 
product.  Normal wear and tear on Seller’s product shall not constitute a warranty defect. 
 

 
These warranties are contingent upon the product being stored, installed, maintained, and 
operated in accordance with good engineering practices and the instructions contained in the 
Operating and Maintenance Manual. Failure to do so shall operate to void all warranties. 
Seller’s total responsibility for damages whether arising in contract or tort arising out of or relating 
to the performance of the product or the warranties hereunder shall be strictly limited to the 
contract price for the product.  In no event shall Seller be liable for any incidental or consequential 
damages such as lost profits, loss of use of productive facilities or equipment, expenses or 
damages incurred in reliance on the product's performance or lost production whether suffered by 
buyer or any third party. 
 
Seller warrants that the products comply with OSHA standards on drive guard design and 
construction (if applicable) in effect at the time of manufacture and makes no other warranty with 
respect to any other standards. Seller shall not be responsible for failure of parts to fit properly 
due to deterioration of or modification to Buyer’s existing equipment for which such parts are 
furnished. 
Seller makes no warranty or guarantee that the product supplied hereunder will comply with the 
performance of Buyer’s existing equipment. 
Seller reserves the right to furnish substitutes for material not available or whose use is restricted.  
 
The use of (a) non-OEM components or (b) non-OEM pump spare parts and/or (c) non-approved 
modifications to the product and/or (d) failure to install a moisture detection relay and/or (e) failure 
to connect the thermal overload protection wiring will operate to void all warranties. 
 
We reserve the right to change the design, construction or material of any part without incurring 
the obligation of installing such changes on pumps already delivered.