Teledyne Tablet Accessory T803 Manual De Usuario
Communications Setup and Operation
Teledyne API T803 CO2/O2 Analyzer Operation Manual
116
5. In the instrument’s SETUP>MORE>COMM>COM2 menu, make the following
settings:
Baud Rate: 115200
COM2 Mode Settings:
Quiet Mode
ON
SECURITY MODE
OFF
Computer Mode
ON
MULTIDROP MODE
OFF
MODBUS RTU
OFF
ENABLE MODEM
OFF
MODBUS ASCII
OFF
ERROR CHECKING
ON
E,8,1 MODE
OFF
XON/XOFF HANDSHAKE
OFF
E,7,1 MODE
OFF
HARDWARE HANDSHAKE OFF
RS-485 MODE
OFF
HARDWARE FIFO
ON
COMMAND PROMPT
OFF
6. Next, configure your communications software, such as APIcom. Use the
COM port determined in Step 4 and the baud rate set in Step 5. The figures
below show how these parameters would be configured in the Instrument
Properties window in APIcom when configuring a new instrument. See the
APIcom manual (PN 07463) for more details.
below show how these parameters would be configured in the Instrument
Properties window in APIcom when configuring a new instrument. See the
APIcom manual (PN 07463) for more details.
Note
USB configuration requires that the baud rates of the instrument
and the PC match; check the PC baud rate and change if needed.
and the PC match; check the PC baud rate and change if needed.
Using the USB port disallows use of the rear panel COM2 port
except for multidrop communication.
except for multidrop communication.
07276B DCN6418