Teledyne Tablet Accessory T803 Manual De Usuario

Getting Started 

Teledyne API T803 CO2/O2 Analyzer Operation Manual 

30    

Pulls ambient air into chassis through side vents and exhausts through rear.  

Connector for three-prong cord to apply AC power to the analyzer.  
CAUTION! The cord’s power specifications (specs) MUST comply with the power 
specs on the analyzer’s rear panel Model number/Volt/Freq information label  

Identifies analyzer’s model number, and provides voltage and frequency specifications 

Inlet connection to be used for any one of the following: 

 

Sample gas 

 

Span gas 

 

Calibration gas 

 

Zero air 

Connect an exhaust gas line of not more than 10 meters long here that leads outside 
the shelter or immediate area surrounding the instrument. 

Not used. 

Not used. 

Not used. 

LEDs indicate receive (RX) and transmit (TX) activity on the when blinking. 

Serial communications port for RS-232 or RS-485.  

Serial communications port for RS-232 only.  

Switch to select either data terminal equipment or data communication equipment 
during RS-232 communication.  

For ouputs to devices such as Programmable Logic Controllers (PLCs). 

For voltage or current loop outputs to a strip chart recorder and/or a data logger.  

For remotely activating the zero and span calibration modes.  

Option for concentration alarms and system warnings. 

Connector for network or Internet remote communication, using Ethernet cable  

Option for external voltage signals from other instrumentation and for logging these 
signals 

Connector for direct connection to personal computer, using USB cable. 

07276B DCN6418