Omega Lift 40500 Manual De Usuario

3

1. Select the correct size spline sleeve.  Place the spline 

on the adapter shaft, then attach to the head plate 

with the release pin & retaining pin provided.

2.  Close  the  release  valve  by  tightening  the  release 

valve knob. Pump the handle to raise the lifting arm 

and align the spline sleeve with the clutch.

3. Tilt the head plate with the tilt adjustment bolt to align 

it with the clutch bore. Slide the spline sleeve into 

the clutch.

4. Remove the clutch mounting bolts and back the jack 

and clutch away from the flywheel.

Be sure the adapter shaft is in the vertical position and 

the jack is fully lowered before transporting, as shown 

in Figure 2.

1. To load or unload a clutch from the jack, be sure the 

adapter shaft is in the vertical position, as shown in 

Figure 2.

2. Add or remove one piece of the clutch at a time.

1.  Raise  the  clutch  into  the  horizontal  position  for 

installation and tilt the clutch using the tilt adjustment 

bolt to align with the flywheel.

2. Put the jack and clutch into position so that the spline 

shaft engages the pilot bearing in the flywheel. Install 

and tighten the clutch mounting bolts.

1.  Verify  that  the  product  and  the  application  are 

compatible, if in doubt call Omega Technical Service 

(888) 332-6419.

2. Before using this product, read the operator's manual 

completely and familiarize yourself thoroughly with 

the  product,  its  components  and  recognize  the 

potential hazards associated with its use.

3. Open the release valve by turning the release valve 

knob counter-clockwise (no more than 1/2 full turn).

4. With lifting arm fully lowered, locate and remove the 

oil filler plug. Pump handle 6 to 8 full strokes. Ensure 

the oil level is within ~3/16" from the inner cylinder 

as viewed from the oil filler hole. Reinstall the oil filler 

plug. Close release valve by turning it clockwise until 

firm resistance is felt.

5. Check to ensure that jack rolls freely, that the pump 

and release valve operate smoothly. Raise and lower 

the unloaded jack throughout the advertised lift range 

before putting into service.

6.  Replace  worn  or  damaged  parts  and  assemblies 

with  Factory Authorized  Replacement  Parts  only. 

Lubricate as instructed in Maintenance Section.

•  Study, understand, and follow all printed materials 

provided with/on this device before use.

•  Do not exceed rated capacity.

•  Use only on hard, level, seamless surface.

•  Do not allow any part of your body under the lift 

arm or load while the jack is supporting a load.

•  Use only the factory supplied adapters as a 

means of contacting the load. Never use any 

other part of the jack as a lifting surface.

•   Use of this jack is limited to the removal, 

installation and transportation of clutch/flywheel.

•  Adequately support the vehicle before starting 

repairs.

•  Failure to heed these markings may result in 

personal injury and/or property damage.

Be sure all tools and personnel are clear before  

lowering load.

Figure 2 - Illustration of Lowest Position with Clutch

Adapter Shaft

Clutch