Ohlins FG 470 Manual De Usuario

CAUTION!
The Washers must be positioned correctly
(Notice that there is a difference between
the compression and the rebound valve).
Also make sure to fi t the Wave washer
(1149-01) in the correct position (convex
side facing piston).

NOTE!
The right hand fork leg is the rebound leg.
The left hand fork leg is the compression
leg.

14.
Fit the Seal head tool and the Top-out
spring tool on the piston rod. Pull the Top-
out spring tool and, at the same time, push
the Seal head tool to contract the Top out
spring. Install tool 2810-01 on tool 1765-
03 to keep the contraction. Assemble the
complete piston rod into the cartridge tube
and tight it by hand (3-4 turns).

NOTE!
Make sure that the gas piston is pressed
down completely

15.
Tighten the Seal head to 20 Nm. Use Seal
head tool (1797-04 and 1765-03).

16.
Check the O-ring on the reservoir cap
assy. Replace if necessary. Apply some red
grease on the O-ring and push the reser-
voir cap assy into the chamber using tool
720-03.

17.
Fit the circlip. Make certain that it enters its
groove properly.

18.
Once again contract the top out spring
using tool 2810-01, tool 1765-03 and tool
1797-04

NOTE!
Nitrogen (N2) gas. Use pressure gauge
(1781-01)

Tool 1765-03

Tool 1797-04

Tool 2810-01

Tool 720-03

20 Nm

NOTE!