Quantum Instruments MS3580 Manual De Usuario

 

 

12 

I

NSTALLATION

 

 

 
1.  Turn off the host device. 

2.  Plug the male 10-pin RJ45 end of 

the USB cable into the 10-pin 
socket on the MS3580. 

3.  Plug the other end of the USB 

interface cable into the host 
device’s USB port. 

4.  Turn on the host device. 

 
 
 
 
 
 
 
 

When the scanner first receives power, the blue LED will turn on; the 
scanner will simultaneously emit a beep and flash the white LED. 

 

As a default, the MS3580-38 leaves the factory with USB Keyboard 
Emulation Mode enabled. 
 
For information on configuring the MS3580-38 for USB Serial 
Emulation Mode, please refer to Section P:  Low Speed USB in the 
MetroSelect Configuration Guide (

MLPN

 00-02407). 

 

Plugging the scanner into the USB port of the PC does not guarantee 
that scanned information will appear at the PC.  A software driver and 
correct configuration setting are also required for proper 
communication to occur. 

 

Caution:  

 

To maintain compliance with applicable standards, all circuits connected to the scanner 
must meet the requirements for SELV (Safety Extra Low Voltage) according to EN/IEC 
60950.  

 

To maintain compliance with standard CSA C22.2 No. 60950/UL 60950 and norm 
EN/IEC 60950, the power source should meet applicable performance requirements for 
a limited power source.