Oceanic ATOM 2.0 Manual De Usuario

Setting FO2 for NORM Nitrox Dives:

For each value of FO2, the Maximum Operating Depth (MOD) that can be achieved for

the PO2 Alarm Set Point limit previously set, will be displayed.

When the FO2 50% DEFAULT is set ON and FO2 GAS 1 is set for a numerical value, 10

minutes on the surface after that dive, the FO2 for GAS 1 will be displayed as 50 and

further dives will be calculated based on 50% O2 for oxygen calculations and 21% O2

for Nitrogen calculations (79% Nitrogen) unless the FO2 for GAS 1 is set before the dive.

FO2 for GAS 1 continues to reset to the FO2 50% DEFAULT after subsequent repetitive

dives until 24 hours elapse after the last dive, or the FO2 50% DEFAULT is turned OFF in

the Set FO2 50% DEFAULT ON/OFF MODE.

When the FO2 50% DEFAULT is set OFF, the ATOM will remain set at the last FO2 GAS 1

Set Points for that series of repetitive dives.

The default FO2 for GAS 1 each new dive Period is AIR.

When FO2 for GAS 1 is set for AIR, the calculations are the same as when it is set to an

FO2 of 21%. When FO2 for GAS 1 is set to AIR, it remains set for AIR until it is set for a

numerical FO2 value (21 to 50%).

When FO2 is set only to AIR, the O2 Bar Graph is not displayed at any time during a dive

or on the surface. PO2 values and/or warnings will not be displayed during the dive.

FREE Dive nitrogen calculations are based on AIR and not affected by these FO2 Settings.