Nortel Networks Video Gaming Accessories 553-3001-211 Manual De Usuario

 NT6D80 MSDL card

Use manual maintenance commands found in the following programs to 
enable, disable, reset, get the status of, and perform self-tests on the MSDL 
card:

•

Input/Output Diagnostic Program LD 37

•

Program  LD 42

•

Link Diagnostic Program LD 48

•

PRI D-channel Diagnostic Program LD 96

For a complete discussion of these programs, refer to Software Input/Output: 
Administration (553-3001-311).

Note 1: Enter commands after the dot (.) prompt.

Note 2:  The “

” in the commands below represents the DNUM value of 

the card number.

Enter 

 to enable the MSDL manually. If the MSDL base code 

has not been previously downloaded or if the card version is different from 
the one on the system disk, the software is downloaded and the card is 
enabled.

To force software download and enable the card, enter 

. 

This command forces the download of the MSDL base code and the 
configured peripheral software even if it is already resident on the card. The 
card is then enabled.

To enable a disabled MSDL and its ports, enter 

. This 

command downloads all peripheral software (if required) and enables any 
configured ports on the card. This command can be issued to enable some 
manually disabled ports on an already enabled MSDL.