Nortel Networks Video Gaming Accessories 553-3001-211 Manual De Usuario

 NT7D16 Data Access card

This mode should be selected when the DAC is connected to a terminal 
(DTE) and Hotline call origination is required. This mode is similar to the 
operation of the ASIM when set to not-forced-DTR and Hotline. In this mode, 
the terminal is able to Hotline to a specific data unit by driving the DTR lead 
ON. The transition of DTR from OFF to ON causes the DAC to Hotline to the 
Autodial DN. Any terminal that drives DTR lead ON can be used with this 
mode (such as VT100 or VT102).

The DAC drives CTS, DSR, and DCD ON, except when a call is dropped. In 
this case, the DAC drives those leads OFF for 0.2 second and then ON. The 
baud rate of the Hotline call is determined by the AUTB and BAUD 
parameters in LD 11.

The DAC must be configured as R232 or R422 since Autodial, Speed Call, 
and Display commands are likely to be used.

This mode should be selected when the DAC is connected to a terminal 
(DTE) for inbound and outbound data calls. This mode is similar to the 
operation of the ASIM when set to forced-DTR and not-Hotline. The terminal 
used with this mode is not required to drive the DTR lead. This mode of 
operation is similar to mode 12, except for the following:

•

The status of DTR lead is assumed to be always ON, even when the 
actual condition of that lead is OFF (forced-DTR). The DAC always 
answers an incoming call regardless of the DTR status.

•

The terminal cannot release an established data call by driving DTR 
OFF. As a result, the terminal cannot initiate call release except with a 
long break or three short breaks.

The DAC must be configured as R232 since Autodial, Speed Call, and 
Display commands are likely to be used.