Nortel Networks Video Gaming Accessories 553-3001-211 Manual De Usuario

 NT7D16 Data Access card

Keyboard Autobaud is allowed after the call is placed in off-line mode.

Note: If the Hayes autobaud characters A or a are sent, the DAC will 
enter Hayes dialing mode. Autobaud character detection is selected in the 
software.

The user can override the downloaded parity rate by entering the ASCII 
period (.) as a command. This period must be the only command sent, 
followed by <CR>. The period must be sent only when the Primary menu is 
displayed, and can be sent only once during a call setup session.

For the purposes of this document, when illustrating the prompt/response 
sequences, the bold type is what the user enters on the keyboard. All other 
type represents the DAC output. Likewise, “xxxxxxx,” “yyyyyyy,” or 
“zzzzzzz” represents numbers entered by the user, or dialed by the DAC, and 
in no way indicates the absolute character limit. A maximum of 43 characters 
is allowed.

When the user enters the autobaud character, <CR>, and the dialing mode is 
Manual (not Hotline), the DAC sends the following menu:

If the user enters <CR>, the DAC presents this prompt again. When a number 
is entered, the DAC attempts to place the call. Entering H at this point will list 
the Primary Commands menu:

<CR><LF><CR><LF><LF>ENTER NUMBER OR H (FOR HELP):<SP>

Primary Commands Menu: 
 

A - Auto Dial C - Call
D - Display M - Modify
S - Speed Call
CTRL Z (Abort Keyboard Dialing)
Select: <SP>