Nortel Networks Video Gaming Accessories 553-3001-211 Manual De Usuario

 NT7D16 Data Access card

Each input record generates a result code which is sent to the user. Only one 
code is sent regardless of the number of commands in the record. The reply 
is in one of two formats:

•

Numeric replies contain a one- or two-number code

•

Verbose replies contain one or more words

Table 154 shows the codes for each reply in both formats, and explanations 
for the codes.

Note 1: Verbose commands are the default and appear in upper case 
characters only. Numeric commands are sent by issuing the Numeric 
Results code command (explained later in this document).

Note 2:  All verbose codes and messages are preceded and terminated 
by the user defined Terminator and New Line characters. The default, or 
reset, characters are the ASCII Carriage Return, and ASCII Line Feed. 
The Numeric codes are preceded and terminated by the Terminator 
character only.

Note 3:  The Suppress result command (explained later in this 
document) will disable the sending of these codes. If in RS-232-C DAC 
Host modes, this command is ignored.

OK

0

Command(s) executed, no error

CONNECT

1

Data call established, session starts

RING

2

Inbound call presented

NO CARRIER

3

Data call abandoned

ERROR

4

Error in command line

NO DIALTONE

6

System does not allow call to proceed