Nortel Networks Video Gaming Accessories 553-3001-211 Manual De Usuario

 NT7D16 Data Access card

All of the Hayes dialing parameters and S registers remain even after the data 
call is complete. Similarly, if the dialing mode, keyboard to Hayes or vice 
versa, are changed, the parameters remain as specified. The following 
command allows you to reset the parameters and S registers to the defaults. 
Entering 0 resets to the Hayes default, while entering 1 resets to the 
downloaded operating parameters.

OK

Table 157 lists all the parameter and S register default values. These are the 
values established when the reset command is given.

This command should only be used to reset all parameters. It should be 
the last command entered, because all previous commands are 
ignored.

C

1 *

DCD controlDynamic (1)
Forced ON (0)

E

1 *

Input character echo Enabled (1)

Disabled (0)

Q

0

Send Result codesEnabled (1)
Disabled (0)

* Parameters that are reset to the downloaded operating parameters when 1 is 
entered at the reset command.