National Instruments Welding System 321645c-01 Manual De Usuario
Chapter 2
Function Reference — SCXI_Set_Config
NI-DAQ FRM for PC Compatibles
2-358
©
National Instruments Corporation
3:
VXI-SC-1000 carrier module.
4:
PXI-1010 chassis.
chassisAddress is the hardware jumpered address of an SCXI chassis.
Range:
0 to 31.
commMode is the communication mode that will be used when the driver communicates
with the SCXI chassis and modules.
with the SCXI chassis and modules.
0:
Communication mode is disabled. In effect, this disables the chassis.
1:
Enables serial communication through a digital port of a DAQ device that is
cabled to a module in the chassis.
cabled to a module in the chassis.
2:
Enables serial communication through the parallel port cabled to an SCXI-1200
in the chassis.
in the chassis.
4:
Enables serial communication over the VXI backplane.
5:
Enables serial communication through a digital port of a DAQ device internally
connected to the SCXIbus of a PXI-1010 chassis.
connected to the SCXIbus of a PXI-1010 chassis.
commPath is the communication path that will be used when the driver communicates with
the SCXI chassis and modules. When commMode = 1, 2, 4, or 5, set the path to the device
number of the DAQ device that is the designated communicator for the chassis. If only one
DAQ device is connected to the chassis, set commPath to the device number of that device.
If more than one DAQ device is connected to modules in the chassis, you must designate one
device as the communicator device, and you should set its device number to commPath.
If commMode is 1 or 2, refer to the connectionMap array description; you should set
commPath to one of the device numbers specified in that array. When commMode = 0,
NI-DAQ ignores commPath.
the SCXI chassis and modules. When commMode = 1, 2, 4, or 5, set the path to the device
number of the DAQ device that is the designated communicator for the chassis. If only one
DAQ device is connected to the chassis, set commPath to the device number of that device.
If more than one DAQ device is connected to modules in the chassis, you must designate one
device as the communicator device, and you should set its device number to commPath.
If commMode is 1 or 2, refer to the connectionMap array description; you should set
commPath to one of the device numbers specified in that array. When commMode = 0,
NI-DAQ ignores commPath.
numSlots is the number of plug-in module slots in the SCXI chassis.
4:
For the SCXI-1000 and PXI-1010 chassis.
12:
For the SCXI-1001 chassis.
modulesPresent is an array of length numSlots that indicates what type of module is present
in each slot. The first element of the array corresponds to slot 1 of the chassis, and so on.
in each slot. The first element of the array corresponds to slot 1 of the chassis, and so on.
–1:
Empty slot; there is no module present in the corresponding slot.
1:
SCXI-1126.
2:
SCXI-1121.
4:
SCXI-1120.
6:
SCXI-1100.
8:
SCXI-1140.
10:
SCXI-1122.
12:
SCXI-1160.
14:
SCXI-1161.
16:
SCXI-1162.
18:
SCXI-1163.
20:
SCXI-1124.