Juniper Networks SRX 210 Manual De Usuario

Connecting to the CLI at the User End for the SRX210 Services Gateway

To remotely connect to the CLI through a dial-up modem connected to the console
port on the services gateway:

1.

Connect a modem at your remote location to a management device such as a
PC or laptop computer.

2.

Start your asynchronous terminal emulation application (such as Microsoft
Windows HyperTerminal) on the PC or laptop computer.

3.

Select the 

COM

 port to which the modem is connected (for example, 

COM1

).

4.

Configure the port settings shown in Table 36 on page 99.

Table 36: Port Settings for Connecting CLI at User End

Value

Port Setting

9600

Bits per second

8

Data bits

None

Parity

1

Stop bits

None

Flow control

5.

In the HyperTerminal window, enter 

AT

.

For more information on the AT commands, see the JUNOS Software
Administration Guide.

An 

OK

 response verifies that the modem can communicate successfully with the

COM

 port on the PC or laptop.

6.

Dial the modem that is connected to the console port on the services gateway
by entering 

ATDT remote-modem-number

. For example, if the number of the

modem connected to the console port on the services gateway is

0013033033030

, enter 

ATDT 0013033033030

.

The services gateway login prompt appears.

7.

Log in as the user 

root

. No password is required at initial connection, but you

must assign a root password before committing any configuration settings.

Related Topics

■

■

■

Connecting to the CLI at the User End for the SRX210 Services Gateway

■

99

Chapter 15: Connecting the SRX210 Services Gateway to Management Devices