Juniper Networks SRX 210 Manual De Usuario
NOTE: The numbers in Figure 8 on page 20 correspond to the numbers in Table 12
on page 21.
on page 21.
Table 12 on page 21 describes the built-in Ethernet port LEDs.
Table 12: SRX210 Services Gateway Built-In Ethernet Port LEDs
Description
State
Color
Function
Number
Link is active. Data
communication is taking place.
communication is taking place.
Blinking
Green
TX/RX/LINK
LED
LED
1
Link is active. No data
communication is taking place.
communication is taking place.
Steady
Link is inactive.
Off
Unlit
PoE (Power over Ethernet) is on
and the connected power device
is receiving power.
and the connected power device
is receiving power.
Steady
Green
PoE LED
2
PoE (Power over Ethernet) is on,
but the connected power device
is not receiving power (device
fault or not enough power).
but the connected power device
is not receiving power (device
fault or not enough power).
Steady
Yellow
PoE is off.
Off
Unlit
NOTE: The PoE LED is enabled only on the Power over Ethernet (PoE) model of the
SRX210 Services Gateway. For non-PoE models, the PoE LED remains off.
SRX210 Services Gateway. For non-PoE models, the PoE LED remains off.
Voice Interface Port LED
On the SRX210 Services Gateway, each Voice Interface (FXO and FXS) port has a
single LED indicating the status.
single LED indicating the status.
SRX210 Services Gateway LEDs
■
21
Chapter 2: SRX210 Services Gateway Hardware Components and Specifications