John Deere OMGX10742 J9 Manual De Usuario
Service - 25
SERVICE
4. Check belt routing. Make sure that upper V-belt is routed
INSIDE the clutch idler pulley (A) and three belt guides (B).
INSIDE the clutch idler pulley (A) and three belt guides (B).
5. Reassemble snowblower to the tractor.
Replacing Lower V-Belt
NOTE: It is not necessary to remove the snowblower
for this procedure. The snowblower was removed for
illustration only.
for this procedure. The snowblower was removed for
illustration only.
1. Remove hair cotter pin from belt tensioner (A) and
loosen lower V-belt tension.
loosen lower V-belt tension.
2. Remove the drive pulley guard (B) from the auger
housing.
housing.
3. Roll lower V-belt off of jack shaft pulley, idlers and
mounting bracket pulley and remove it from the
snowblower.
mounting bracket pulley and remove it from the
snowblower.
4. Install new V-belt under two idler pulleys (C) and roll it
around the jack shaft pulley (D) inside the auger housing.
around the jack shaft pulley (D) inside the auger housing.
IMPORTANT: Avoid damage! Route upper V-belt
INSIDE three belt guides. Routing belt incorrectly
can cause belt damage.
INSIDE three belt guides. Routing belt incorrectly
can cause belt damage.
K
B
B
B
A
A
B
D
C