Motorola PTP 400 Series Manual De Usuario

 

 

32

3.3.4  Remote LEDs and Recovery Switch 

The PTP 400 Series Bridge PIDU Plus provides a facility to connect remote LEDs and 

Recovery switch allowing the PIDU Plus to be mounted inside an enclosure. At the left end of 

the PIDU Plus under the ODU connection cover can be found three jumpers and a PCB 

header. Jumpers J906 and J907 should be removed and connection to the remote LEDs and 

Recovery switch made to J908 as shown in Figure 9. 

 

3.3.5  Cables and Connectors

 

 

The cable used to connect the PTP 400 Series PIDU Plus to the ODU can be any standard 

CAT 5 type provided that it is suitable for outdoor deployment. Motorola recommends that 

cables to the specification below be used.  

NEC/CEC: CMR (ETL) C (ETL) 75C SUN RES OIL RES II  

Failure to use the recommended (or equivalent) standard of cable may invalidate the 

system’s safety certification.  

The PIDU Plus/ODU cable may be unscreened (UTP) or screened (STP). However, 

unscreened cables reduce the system’s ability to cope with nearby lightning strikes. If 

lightning activity is common in the area of deployment, the use of screened cable is highly 

recommended. See Section 11 “Lightning Protection”.