MINOLTA dimage7 Visión De Conjunto
26
27
EXTERNAL POWER SUPPLIES
(SOLD SEPARATELY)
CHANGING THE COMPACTFLASH CARD
BASIC OPERATION
The AC Adapter allows the camera to be powered from an electrical household outlet. ,
The AC Adapter is recommended when the camera is interfaced with a computer or
during periods of heavy use. AC Adapter model AC-1L is for use in North America, and
AC-2L is for use in all other areas.
The AC Adapter is recommended when the camera is interfaced with a computer or
during periods of heavy use. AC Adapter model AC-1L is for use in North America, and
AC-2L is for use in all other areas.
The External High-power Battery Pack Kit EBP-100 is a portable source of power for
the camera. This battery pack will significantly extend the operating time of the camera.
the camera. This battery pack will significantly extend the operating time of the camera.
Insert the mini plug of the AC adapter or battery
pack into the DC terminal.
pack into the DC terminal.
• Always remove exhausted batteries before
connecting an external power supply.
Insert the AC adapter plug into an electrical outlet.
Remove the DC terminal cover by using the notch
on the right.
on the right.
• The cover is attached to the body to prevent loss.
A CompactFlash card must be inserted for the camera to operate. If a card has not
been inserted, a no-card warning will automatically be displayed on the monitors. IBM
Microdrives are compatible with this camera. For recording media care and storage,
see page 143.
been inserted, a no-card warning will automatically be displayed on the monitors. IBM
Microdrives are compatible with this camera. For recording media care and storage,
see page 143.
Open the card-slot door in the direction indicated (1).
Insert the CompactFlash card into the card slot until the card-eject lever pops out (4).
• Insert the card so the face is toward the front of the camera. Always push the card in straight,
never at an angle. Never force the card. If the card does not fit, check that it is orientated
correctly.
correctly.
Fold the card-eject lever down as shown (5) and close the card-slot door.
To eject a CompactFlash card, lift (2) then press (3) the card-eject lever. The card can
now be pulled out.
now be pulled out.
• Take care when removing the card as it becomes hot with use.
If the card-not-recognized message appears, the inserted card in the camera may need
to be formatted. A CompactFlash card used in another camera may have to be format-
ted before being used. If the unable-to-use-card message appears, the card is not
compatible with the camera and should not be formatted. A card can be formatted in
the basic section of the setup menu (p. 116). When a card is formatted, all the data on
the card is permanently erased.
to be formatted. A CompactFlash card used in another camera may have to be format-
ted before being used. If the unable-to-use-card message appears, the card is not
compatible with the camera and should not be formatted. A card can be formatted in
the basic section of the setup menu (p. 116). When a card is formatted, all the data on
the card is permanently erased.
1
2
3
4
5
Always turn off the camera and confirm the access lamp is not lit before inserting or
removing a CompactFlash card, otherwise the card may be damaged, and data lost.
Do not change the power supply while the camera is on.
Always turn off the camera before changing between power supplies.