Meyer Sound SIM 3 Manual De Usuario
10
section 3: setup
physiCal setup without router
In order to operate a SIM 3 machine remotely without using a wireless router connect the computer to the SIM machine
with a CAT5 or better cable. Modern computers automatically apply an internal crossover when necessary – if using an
older computer please use a crossover cable.
with a CAT5 or better cable. Modern computers automatically apply an internal crossover when necessary – if using an
older computer please use a crossover cable.
1. Power up the SIM 3 machine and immediately insert the Software CD (See page 4) into the CD drive of the SIM 3
machine. This must be done the moment the SIM 3 is turned on.
If the SIM 3 boots up as usual then the CD was introduced too late. This is not a problem. Just power down the SIM 3
down (by holding the power button) without removing the CD. The next time it powers up it will automatically boot from
the CD drive.
down (by holding the power button) without removing the CD. The next time it powers up it will automatically boot from
the CD drive.
2. The SIM 3 machine will boot and present a terminal window in the upper left corner of the display (if a monitor is
attached to the SIM 3 machine).
When setting the computer’s Ethernet adaptor properties please make sure you set the following values:
You should have a similar display:
CAT5
windows
os X