Mercury Marine SC1000 Manual De Usuario
WARNING SYSTEM
7
NOTE: Not all screens may apply to your engine type.
MODE
RPM x 1000
0
2
3
4
5
6
7
1
RESET
TROLL
+
TROLL
-
FAULT
BATTERY
FAULT
FAULT
FAULT
FAULT
FAULT
SENSOR
WATER TEMP
OIL TEMP
22892
ENGINE
DATA BUS
IGNITION
NO STARBOARD
ENGINE
ENGINE
MULTIPLE STARBOARD
ENGINE
8V
18V
9
10
11
12
13
14
15
16
9. FAULT - IGNITION: A problem has developed in the ignition
system.
10. BATTERY: The electrical system is not charging or the battery
charge is low.
11. ENGINE DATA BUS: The data communication link between
the tachometer and engine is not connected.
12. FAULT - SENSOR: One of the sensors is not functioning
correctly.
13. FAULT - WATER TEMP: The sensor for measuring outside
lake/sea water temperature is not functioning correctly.
14. NO STARBOARD ENGINE: The instrument does not detect
the starboard engine computer. This usually indicates that no
data is being transferred from the engine's computer to the
gauge. Check the wiring. Make sure both terminator resistors
are installed in the bus. Make sure both ECMs are not
configured for the port location using a DDT or Quicksilver
Diagnostic Tool.
data is being transferred from the engine's computer to the
gauge. Check the wiring. Make sure both terminator resistors
are installed in the bus. Make sure both ECMs are not
configured for the port location using a DDT or Quicksilver
Diagnostic Tool.
15. MULTIPLE STARBOARD ENGINE: SmartCraft gauges are
recognizing multiple engines as starboard.
NOTE: In multiple engine applications, each engine must first be
assigned a position (starboard, port, starboard2 or port2) with a
Computer Diagnostic Tool (CDS) before the system will function
properly.
assigned a position (starboard, port, starboard2 or port2) with a
Computer Diagnostic Tool (CDS) before the system will function
properly.
16. OIL TEMPERATURE: The engine oil is overheating.