LaCie 12big Rack Storage Server Manual De Usuario

LaCie Quick Install Guide 

4

1.  Inspect the packaging for crushes, cuts, water damage or any other 

evidence of mishandling during transit. If any damage appears pres-
ent, photograph the packaging before opening, for reference.

2.  Unpack the system. See Figure 1.

 The rail kit is suitable for 19” racks with square and round holes 

only. The minimum distance between vertical rack posts is 24” (610mm); 
the maximum distance is 36” (914mm). The rail location pins are pre-
assembled to suit square hole or round hole racks. The pins should not 
be removed.

1.  Remove the Rack Mounting Rail Kit from the Accessory Box and 

check for damage.

2.  Ensure the pre-assembled rails are at their shortest length.

3.  Locate the rail location pins inside the front of the rack and extend 

the rails to enable the rear location pins to engage. Ensure the pins 
are fully located in the holes in the rack posts (see Figure 2).

4.  Install the front and rar clamping screws (see Figure 2). The screws 

should be left loose enough to allow the rail to move sideways on 
its slots.

5.  Slide the enclosure fully home on its rails.

6.  Withdraw the enclosure approximately 200mm and fully tighten the 

front and rear clamping screws (see Figure 2).

7.  Fasten the front of the enclosure using the two captive screws a 

shown in Figure 2.