Ingersoll-Rand SRV125F Manual De Usuario
1
P7630 Edition 1
Form P7648
Edition 1
August 2004
CCN 04579728
Edition 1
August 2004
CCN 04579728
Operation and Maintenance Manual
for
Series SRV125F
Starter Relay Valve
Series SRV125F Starter Relay valves are designed for controlling fluid flow in conjunction with Air Starting
Systems
.
• IMPORTANT SAFETY INFORMATION ENCLOSED - SAVE THESE INSTRUCTIONS.
•
•
Read and understand this manual before operating Valve.
• Failure to observe the following warnings could result in injury.
PLACING THE VALVE IN SERVICE
•
Always install, operate, inspect and maintain this prod-
uct in accordance with all applicable standards and reg-
ulations (local, state, country, federal, etc.).
uct in accordance with all applicable standards and reg-
ulations (local, state, country, federal, etc.).
•
Always use clean, dry air at a pressure which does not
exceed the pressure rating listed on the valve.
exceed the pressure rating listed on the valve.
•
Do not use damaged, frayed or deteriorated air hoses &
fittings.
fittings.
•
Always turn off the air and disconnect the air hose
before installing, removing or adjusting any accessory
on this valve, or before performing any maintenance on
this valve or accessory.
before installing, removing or adjusting any accessory
on this valve, or before performing any maintenance on
this valve or accessory.
•
Do not lubricate the valve with flammable or volatile
liquids such as kerosene, diesel or jet fuel, use only
recommended lubricants.
liquids such as kerosene, diesel or jet fuel, use only
recommended lubricants.
•
Series SRV125F Valves are not designed for working
in explosive atmospheres.
in explosive atmospheres.
•
Do not remove any labels, replace any damaged labels.
•
Operate this valve only when properly installed in the
Air Starting System.
Air Starting System.
•
Always bleed off the air pressure before attempting to
remove the Starter Relay Valve from the Receiver or
before attempting to perform any maintenance on the
Starter Relay Valve.
remove the Starter Relay Valve from the Receiver or
before attempting to perform any maintenance on the
Starter Relay Valve.
•
Never attempt to remove the Retaining Ring (12) from
the bottom side of the Starter Relay Valve until the air
pressure has bled off. If the Retaining Ring is removed
while there is pressure in the Receiver, internal parts of
the Starter Relay Valve will be blown out with consid-
erable force.
the bottom side of the Starter Relay Valve until the air
pressure has bled off. If the Retaining Ring is removed
while there is pressure in the Receiver, internal parts of
the Starter Relay Valve will be blown out with consid-
erable force.
•
Use only recommended Ingersoll-Rand accessories.
NOTICE
WARNING
Refer All Communications to the Nearest
Ingersoll-Rand Office or Distributor.
© Ingersoll-Rand Company 2004
Printed in U.S.A
Ingersoll-Rand Office or Distributor.
© Ingersoll-Rand Company 2004
Printed in U.S.A