IBM 715 P/N - 13H6715 Manual De Usuario

Page 34 of 47

SYMPTOM   CD-ROM drive does not operate

SOLUTION  Run the CONFIG.EXE program to ensure that there are no base I/O address

conflicts, or refer to "

" for information about the configuration

defaults.  Ensure that the device line, DEVICE=C:\DSP2\SOLO\
MWDDSOLO.EXE appears before the CD-ROM device driver line in your
CONFIG.SYS file.
If the CD does not play with Windows applications, make sure a CD is in the CD-
ROM drive when you start Windows.  If not, restart Windows with a CD in the
CD-ROM drive.

SYMPTOM   After software installation the disk drive does not work

SOLUTION  This is probably caused by a DMA conflict. Rerun the CONFIG.EXE or

CONFIGO.EXE program and choose a different DMA channel setting for the
Multimedia Modem Plus adapter.

Use this section to solve operational problems.

PROBLEM 

  Need a test method for the modem function

CAUSES/SOLUTION  Close all audio applications, initialize the modem, open your modem

application and do the following from the application terminal screen:

1.

 

Type ATZ and press Enter.  Your modem displays OK on the screen
within 5 seconds.

2.

 

Type ATH1 and press Enter.  The ATH1 command is the same as
taking the receiver off the hook, you will hear a dial tone through your
speakers.

3.

 

Type ATH and press Enter.  The ATH command is the same as
hanging up.

PROBLEM 

  Fax and modem operation is interrupted by incoming calls

CAUSES/SOLUTION  If you have call-waiting, disable call-waiting before you make fax or

modem calls, or call your phone company and ask them to disconnect
your call-waiting service.