IBM Telephone 412 Manual De Usuario
17
LIST OF SYSTEM DEFAULTS
The default telephone setup is as follows:
You may clear all programmed data and all the parameters will revert to the above default values. To
You may clear all programmed data and all the parameters will revert to the above default values. To
do this:
1. Press [STORE].
2. Press [*], [#], [*], [#].
3. Press [MUTE].
4. A short ring will be heard to signal successful programming.
2. Press [*], [#], [*], [#].
3. Press [MUTE].
4. A short ring will be heard to signal successful programming.
ASSIGNING EXTENSION NUMBERS (11 THROUGH 22)
When you use two or more telephones, each telephone must be assigned a different extension num-
ber. If two stations are given the same number, you will hear a loud continuous warning alerting you to
the system error.
All phones arrive with the default extension number 11. Valid extension numbers are 11 through 22.
All phones arrive with the default extension number 11. Valid extension numbers are 11 through 22.
To program extension numbers, follow these steps, assigning numbers sequentially to each extension:
1. Press [STORE].
2. Press [1], [0].
3. Enter 2 digits XX where XX is a number from 11 to 22.
4. Press [MUTE].
5. A short ring will be heard to signal successful programming.
2. Press [1], [0].
3. Enter 2 digits XX where XX is a number from 11 to 22.
4. Press [MUTE].
5. A short ring will be heard to signal successful programming.
TELEPHONE OPERATIONS SETUP
Function
Default
Tone/Pulse Mode
Tone
Headset
Disable
Extension Number
11
Ringer
On — 4 lines
Line Connection
On — 4 lines
Speaker Volume
12th level
Handset Volume
Minimum level
Headset Volume
Middle level
Ringer Volume
Middle level
Speed Dial
Empty
Area Code
Empty