Hypercom ICE 5700 ICE 5700 Manual De Usuario

Large-Area Coverage

If the area to be serviced is too large for the extended basic coverage, configure the system for large-
area coverage. (See Figure 4-3.) Add a power supply, Hypercom P/N 870003-001, to the terminal 
transceiver interface. The premises wiring may be expanded to support an additional eight terminal 
transceivers for a total of ten, maximizing the system for large areas or to fill in gaps in coverage. 

Figure 4-3. Large area coverage

Installing Large Area Coverage

To install large area coverage:

1.

Ensure the host terminal is properly configured and connected for use as a standard POS 
terminal.

See the manual provided with the host POS terminal.

2.

Insert one end of the PIN pad cable, Hypercom P/N 810022-001, into the PIN pad port of the host 
POS terminal. Insert the other end of the PIN pad cable into the connector marked To Terminal on 
the terminal transceiver interface, Hypercom P/N 020192-001.

3.

Mount the terminal transceivers, Hypercom P/N 020123-002, to a vertical surface. Place them as 
high as possible in an area that has the best visibility from the areas where the peripheral terminal 
devices are used. Separate the transceivers as far as possible from each other while still providing 
the required coverage. You may mount the transceivers by using the metal hook or the rubber 
suction cups provided. An alternate method is to remove the metal hook and the rubber suction 
cups, replacing them with double-sided tape. The terminal transceivers must not be mounted on 
or next to metal objects.