Husqvarna Planer CG 200 S Manual De Usuario
23
English
• After some hours of use, carry out a general
retightening of all nuts and bolt.
• Clean machine after each use.
• Lubricate moderately the grease nipples:
- of the rolling bearings (P) [
SEE FIG.
8].
- of the cam (Q).
- of the depth adjustment bearing (R).
10
Maintenance
(machine disconnected)
- Take care to avoid accidental
damage.
OIL
• Check the engine oil every day. Refer to the
engine manual for the replacement schedule. Use:
- SAE 10W30 motor oil with API class MS, SD,
- SAE 10W30 motor oil with API class MS, SD,
SE or better for PETROL engines.
• To empty the motor, place a funnel at the drain
outlet (V) [
SEE FIG.
X
9].
Store in a dry place, not accessible to
children.
children.
Maintain the tools carefully.
FAULT FINDING
In the event of faulty operation refer to the tables
below to find a solution.
below to find a solution.
Dispose of the old oil as laid down by
the regulations in force.
the regulations in force.
CAUSES
• Motor or drum does not rotate
(cont)
Switch defective,
motor cable damaged
motor cable damaged
Motor faulty (no
power, unpleasant
smell)
power, unpleasant
smell)
Does not start (petrol
engine)
engine)
Belt broken
Drum stuck
- Have tested by an
electrician or contact
the service
department
the service
department
- Contact the service
department to have
the motor replaced
the motor replaced
- Engine stopped.
- Faulty or loose spark
- Faulty or loose spark
plug.
- Refer to engine
servicing instructions
or contact after sales
service.
or contact after sales
service.
- Contact the parts
department for a
replacement.
replacement.
- Check that the drum
rotates, remove
whatever is preventing
rotation.
whatever is preventing
rotation.
REMEDIES
CAUSES
• Motor or drum does not rotate
Not plugged in
properly or cable
damaged
properly or cable
damaged
No mains voltage
- Make sure that the
supply is correctly
plugged in (plug,
extension lead, etc)
plugged in (plug,
extension lead, etc)
- Check the supply
cable
- Test or have tested
by an electrician
(circuit breaker, plug,
etc)
(circuit breaker, plug,
etc)
REMEDIES
CAUSES
• Difficult starting
Drum rubs against
ground
ground
Single phase motor
starting condenser
starting condenser
Faulty three phase
supply (2 phases only
or motor cable in poor
condition)
supply (2 phases only
or motor cable in poor
condition)
-Free the drum to
make it easier to
start.
start.
- Replace the
condenser.
- Have it checked by
an electrician or
contact the service
department.
contact the service
department.
REMEDIES
CAUSES
• Ineffective operation with jerks and
considerable vibration
- No noticeable work
done
- Drum at lowest
position
- Maximum wear
- Abnormal vibration
when grooving or
milling
milling
- Abnormal cutter
wear
- Check the setting of
the drum (mills)
- Change the drum or
the cutters, brush,
etc . . .
etc . . .
- Check the rotation of
the cutters on the
four shafts.
four shafts.
- Change the drum or
the cutters.
REMEDIES