Hughes HN7700S Manual De Usuario

 

comply with the applicable FCC Part 68 rules and requirements 
adopted by the ACTA. A compliant 26 Gauge telephone cord and 
modular plug is provided with this product. It is required to be 
terminated with a plug type 605 or a FCC plug type 6 position for 
Australia. 

This section applies to the HN7700S only. 

The REN is used to determine the number of devices that may be 
connected to a telephone line. Excessive RENs on the telephone 
line may result in the devices not ringing in response to an 
incoming call. In most, but not all areas, the sum of RENs should 
not exceed five (5.0). To be certain of the number of devices that 
may be connected to the line, as determined by the total RENs, 
contact the local Telephone Company. For products approved 
after July 23, 2001, the REN for this product is part of the product 
identifier that has the format US:5L4DT##B1032021.

The digits represented by the ## are the REN without the decimal 
point (e.g., 00 is a REN of 0.0). For earlier products, the REN is 
separately shown on the label.

This section applies to the HN7700S only. 

If the Two-Way Hughes System causes harm to the telephone 
network, the Telephone Company will notify you in advance that 
temporary discontinuance of service may be required. But if 
advance notice isn’t practical, the Telephone Company will notify 
the customer as soon as possible. Also, you will be advised of 
your right to file a complaint with the FCC if you believe it is 
necessary.

If phone service is discontinued and you believe it is due to the 
HN7700S terminal, please contact Hughes Customer Care or 
your service provider.

This section applies to the HN7700S only. 

The Telephone Company may make changes in its facilities, 
equipment, operations, or procedures that could affect the 
operation of the equipment. If this happens, the Telephone