Hughes HN7700S Manual De Usuario

 

• Internet Explorer 6.0 or later with proxy settings disabled. 

See Appendix C – Disabling a Web browser’s proxy 
connection, on page 89.

• The latest version of the terr

 file if you are instructed 

to install it.

• All existing firewall software must be disabled.

The HN router can be used with any device that supports IP and 
has a 10/100 BaseT Ethernet port. Typically, the router is 
connected to a customer's computer. To run software that may be 
installed to support the router, the customer’s computer must 
meet the following requirements:

• Operating system

– PC: Windows Vista, Windows XP, Windows 2000 
– MAC: 10.1 and higher

• Processor

– Vista PC: 800 Mhz or faster
– All other PCs: Pentium II 333 Mhz or faster
– MAC: 300 Mhz or faster

• Memory

– Vista PC: 512MB or 1 GB RAM depending on version
– All other PCs: 128MB RAM
– MAC: 128MB

• Free hard drive space

– PC: 100MB
– MAC: 150MB

• A functioning 10/100 BaseT Ethernet interface installed on at 

least one computer. 

• The customer must provide a power strip or surge protector 

(recommended). If one of these is not present, use a wall 
outlet or other power source.

• The customer must have a WAN transport, for example DSL, 

available at their site that is ready for connection to and 
compatible with the modem that is to be attached to the HN 
router.            

Note:

Confirm that the installer laptop PC is configured to 

support Dynamic Host Control Protocol (DHCP) prior to 
beginning the installation. See Appendix A – Configuring a 
computer to support DHCP on page 69.