Honeywell Network Hardware NETAXS-123 Manual De Usuario

6. Connect the Ethernet cable and the Tamper wire, as shown below.

7. Set DIP switch settings for the panel address, communication termination and biasing. See 

, page 36.

8. Check all wiring at this time.

Improper wiring can cause damage to the NetAXS-123 at power up and result in a loss 

of warranty.

9. Apply power to the panel. 

10.Check for the Run LED for a successful power-up. If the LED is blinking green, the panel is 

powered up successfully.

11.Close the cover.