Honeywell Galaxy 3-48C Instruccion De Instalación

The Ethernet Module is an optional add-on to the Galaxy 3-144 and 3-520 panels. It is a highly intelligent and
compact module, combining alarm signalling, remote servicing and integrated facilities over Ethernet LAN and/
or WAN. The Ethernet Module connects to 10 Base T Ethernet networks both supporting UDP/IP and TCP/
IP protocols.
The Ethernet module supports the following features:
•

Full alarm signalling on SIA

•

Microtech protocol signalling with Alarm Monitoring Software V3.1/3.2

•

Remote servicing via remote servicing software

NOTE: The position of components on the Ethernet PCB may vary with different hardware revisions

The added Ethernet Module is configured into the system on exiting from engineer mode and is allocated
keypad address 15 (B).  If the message XX Mod Added [<],[>] To View is displayed, the system has
recognised that a new module is present.  Press the A or B keys to confirm that com 4 has been added.  If
this message is not displayed or the Ethernet Module is not on the list of added modules, then the Ethernet
Module is not communicating with the control panel.

The flash rate of the red LED (LED3) on the Ethernet Module indicates the status of the communication with
the control.

The green LED (LED1) is illuminated when the Ethernet Module is connected to Ethernet.
The amber LED (LED2) flashes when the Ethernet Module is sending or receiving data.

For further information regarding the Ethernet Module, refer to Ethernet Module, Installation Instructions
(II1-0080).

Processor

Programming
Header

Engineer
Socket

S

+

-

A

B

Line

Processor

SKT1

SKT2

LED1

LED2

Rev. 1.0

LED3